Front Hot-Swap Drive And Front Drive Backplane Replacement - Lenovo ThinkEdge SE455 V3 User Manual

Figure 65. Installing the fan cage
After this task is completed
1. Reinstall all the fan modules. See
2. Complete the parts replacement. See

Front hot-swap drive and front drive backplane replacement

Follow instructions in this section to remove and install the front hot-swap drives and the front drive
backplane.
Remove a front hot-swap drive
Follow instructions in this section to remove a front hot-swap drive.
About this task
Attention:
• Read "Installation Guidelines" on page 39
work safely.
• If applicable, remove the security bezel. See
• To make sure that there is adequate system cooling, do not operate the server for more than two minutes
without either a drive or a filler installed in each bay.
• If one or more NVMe solid-state drives are to be removed, it is recommended to disable them beforehand
via the operating system.
• Before you remove or make changes to drives, drive controllers (including controllers that are integrated
on the system board), drive backplanes or drive cables, back up all important data that is stored on drives.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Notes:
"Install a fan module" on page
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 40
"Remove the security bezel" on page
90.
225.
195.
.
Chapter 5 Hardware replacement procedures
to ensure that you
97