Figure 29. Installing the CMOS battery
a.
Tilt the battery and insert it to the positive end on the socket. Make sure that the battery
goes tight to the metal clip.
b.
Press the battery down until it clicks into the socket.
After you finish
1. Complete the parts replacement. See
2. Use the Setup utility to set the date, time, and any passwords.
Front drive backplane replacement
Follow instructions in this section to remove and install a front drive backplane.
•
"Remove the front 2.5-inch drive backplane" on page 65
•
"Install the front 2.5-inch drive backplane" on page 67
•
"Remove the front 3.5-inch drive backplane" on page 70
•
"Install the front 3.5-inch drive backplane" on page 71
Remove the front 2.5-inch drive backplane
Follow instructions in this section to remove the front 2.5-inch drive backplane.
About this task
Attention:
• Read
"Installation Guidelines" on page 39
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Before you remove or make changes to drives, drive controllers (including controllers that are integrated
on the system board assembly), drive backplanes or drive cables, back up all important data that is stored
on drives.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
"Complete the parts replacement" on page
and
"Safety inspection checklist" on page 40
48.
164.
.
Chapter 5
Hardware replacement procedures
to ensure that you
65