Cisco Catalyst 3750 Software Configuration Manual page 48

Default Settings After Initial Switch Configuration
Table 1-1 Default Settings After Initial Switch Configuration (continued)
Feature
Port-based Traffic
Broadcast, multicast, and unicast storm
control
Protected ports
Unicast and multicast traffic flooding
Secure ports
CDP
UDLD
SPAN and RSPAN
RMON
Syslog messages
SNMP
ACLs
QoS
EtherChannels
IP unicast routing
IP routing (and routing protocols)
Multi-VRF-CE
MPLS services
Label switching
EoMPLS
MPLS QoS
HSRP groups
IP multicast routing
MSDP
Fallback bridging
Catalyst 3750 Metro Switch Software Configuration Guide
1-10
Default Setting
Disabled
None defined
Not blocked
None configured
Enabled
Disabled
Disabled
Disabled
Enabled; displayed on the console
Enabled; version 1
None configured
Disabled
None configured
Disabled
Disabled
Globally enabled; disabled per
interface
Not configured
Disabled
None configured
Disabled on all interfaces
Disabled
Not configured
Chapter 1
More information in...
Chapter 18, "Configuring Port-Based
Traffic Control"
Chapter 19, "Configuring CDP"
Chapter 20, "Configuring UDLD"
Chapter 21, "Configuring SPAN and
RSPAN"
Chapter 22, "Configuring RMON"
Chapter 23, "Configuring System Message
Logging"
Chapter 24, "Configuring SNMP"
Chapter 25, "Configuring Network
Security with ACLs"
Chapter 26, "Configuring QoS"
Chapter 27, "Configuring EtherChannels"
Chapter 28, "Configuring IP Unicast
Routing"
Chapter 30, "Configuring MPLS and
EoMPLS"
Chapter 29, "Configuring HSRP"
Chapter 31, "Configuring IP Multicast
Routing"
Chapter 32, "Configuring MSDP"
Chapter 33, "Configuring Fallback
Bridging"
Overview
78-15870-01