Cisco Catalyst 3750 Software Configuration Manual page 796

Configuring MSDP
Command
Step 3 access-list access-list-number {deny |
permit} source [source-wildcard]
or
access-list access-list-number {deny |
permit} protocol source source-wildcard
destination destination-wildcard
Step 4 end
Step 5
show running-config
Step 6
copy running-config startup-config
To remove the filter, use the no ip msdp redistribute global configuration command.
Catalyst 3750 Metro Switch Software Configuration Guide
32-10
Purpose
Create an IP standard access list, repeating the command as many times
as necessary.
or
Create an IP extended access list, repeating the command as many times
as necessary.
• For access-list-number, the range is 1 to 99 for standard access lists
and 100 to 199 for extended lists. Enter the same number created in
Step 2.
The deny keyword denies access if the conditions are matched. The
•
permit keyword permits access if the conditions are matched.
For protocol, enter ip as the protocol name.
•
For source, enter the number of the network or host from which the
•
packet is being sent.
For source-wildcard, enter the wildcard bits in dotted decimal
•
notation to be applied to the source. Place ones in the bit positions
that you want to ignore.
For destination, enter the number of the network or host to which
•
the packet is being sent.
For destination-wildcard, enter the wildcard bits in dotted decimal
•
notation to be applied to the destination. Place ones in the bit
positions that you want to ignore.
Recall that the access list is always terminated by an implicit deny
statement for everything.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 32 Configuring MSDP
78-15870-01