Configuring The Unix System Logging Facility - Cisco Catalyst 3750 Software Configuration Manual

Chapter 23 Configuring System Message Logging
Step 1 Add a line such as the following to the file /etc/syslog.conf:
local7.debug /usr/adm/logs/
The local7 keyword specifies the logging facility to be used; see
information on the facilities. The debug keyword specifies the syslog level; see
for information on the severity levels. The syslog daemon sends messages at this level or at a more severe
level to the file specified in the next field. The file must already exist, and the syslog daemon must have
permission to write to it.
Step 2 Create the log file by entering these commands at the UNIX shell prompt:
$ touch /var/log/
$ chmod 666 /var/log/
Make sure the syslog daemon reads the new changes:
Step 3
$ kill -HUP `cat /etc/syslog.pid`
For more information, see the man syslog.conf and man syslogd commands on your UNIX system.

Configuring the UNIX System Logging Facility

When sending system log messages to an external device, you can cause the switch to identify its
messages as originating from any of the UNIX syslog facilities.
Beginning in privileged EXEC mode, follow these steps to configure UNIX system facility message
logging. This procedure is optional.
Command
Step 1 configure terminal
Step 2
logging host
Step 3
logging trap level
Step 4 logging facility facility-type
Step 5
end
Step 6
show running-config
Step 7 copy running-config startup-config
To remove a syslog server, use the no logging host global configuration command, and specify the syslog
server IP address. To disable logging to syslog servers, enter the no logging trap global configuration
command.
Table 23-4
facilities, consult the operator's manual for your UNIX operating system.
78-15870-01
cisco.log
cisco.log
cisco.log
Purpose
Enter global configuration mode.
Log messages to a UNIX syslog server host by entering its IP address.
To build a list of syslog servers that receive logging messages, enter this
command more than once.
Limit messages logged to the syslog servers.
Be default, syslog servers receive informational messages and lower. See
Table 23-3 on page 23-9
Configure the syslog facility. See
facility-type keywords.
The default is local7.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
lists the UNIX system facilities supported by the software. For more information about these
Configuring System Message Logging
Table 23-4 on page 23-12
for level keywords.
Table 23-4 on page 23-12
Catalyst 3750 Metro Switch Software Configuration Guide
for
Table 23-3 on page 23-9
for
23-11