Disabling And Enabling Cdp On An Interface - Cisco Catalyst 3750 Software Configuration Manual

Configuring CDP

Disabling and Enabling CDP on an Interface

CDP is enabled by default on all supported interfaces to send and receive CDP information.
Beginning in privileged EXEC mode, follow these steps to disable CDP on an interface:
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
no cdp enable
Step 4 end
Step 5
copy running-config startup-config
Beginning in privileged EXEC mode, follow these steps to enable CDP on an interface when it has been
disabled:
Command
Step 1 configure terminal
Step 2
interface interface-id
Step 3
cdp enable
Step 4 end
Step 5 copy running-config startup-config
This example shows how to enable CDP on a port when it has been disabled.
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# cdp enable
Switch(config-if)# end
Catalyst 3750 Metro Switch Software Configuration Guide
19-4
Purpose
Enter global configuration mode.
Enter interface configuration mode, and enter the interface on which
you are disabling CDP.
Disable CDP on an interface.
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Enter interface configuration mode, and enter the interface on which
you are enabling CDP.
Enable CDP on an interface after disabling it.
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
Chapter 19 Configuring CDP
78-15870-01