Incremental (Partial) Configuration; Synchronized Configuration; Configuring Cns Embedded Agents; Enabling Automated Cns Configuration - Cisco Catalyst 3750 Software Configuration Manual

Configuring CNS Embedded Agents

Incremental (Partial) Configuration

After the network is running, you can add new services by using the CNS configuration agent. You can
send incremental (partial) configurations to the switch. You can send the actual configuration as an event
payload by way of the event gateway (push operation), or as a signal event that triggers the switch to
initiate a pull operation.
The switch can check the syntax of the configuration before applying it. If the syntax is correct, the
switch applies the incremental configuration and publishes an event that signals success to the
configuration server. If the switch does not apply the incremental configuration, it publishes an event
showing an error status. When the switch has applied the incremental configuration, it can write it to
NVRAM or wait until signaled to do so.

Synchronized Configuration

When the switch receives a configuration, it can defer application of the configuration upon receipt of a
write-signal event. The write-signal event tells the switch not to save the updated configuration into its
NVRAM. The switch uses the updated configuration as its running configuration. This ensures that the
switch configuration is synchronized with other network activities before saving the configuration in
NVRAM for use at the next reboot.
Configuring CNS Embedded Agents
The CNS agents embedded in the switch Cisco IOS software allow the switch to be connected and
automatically configured as described in the
page
for instructions:
•
•

Enabling Automated CNS Configuration

To enable automated CNS configuration of the switch, you must first complete the prerequisites in
Table
begins the initial configuration as described in the
full configuration file is loaded on your switch, you need to do nothing else.
Table 4-1
Device
Access switch
Distribution switch
Catalyst 3750 Metro Switch Software Configuration Guide
4-6
4-6. If you want to change the configuration or install a custom configuration, see these sections
Enabling the CNS Event Agent, page 4-8
Enabling the CNS Configuration Agent, page 4-9
4-1. When you complete them, power on the switch. At the setup prompt, do nothing: The switch
Prerequisites for Enabling Automatic Configuration
"Enabling Automated CNS Configuration" section on
"Initial Configuration" section on page
Required Configuration
Factory default (no configuration file)
• IP helper address
• Enable DHCP relay agent
• IP routing (if used as default gateway)
Chapter 4 Configuring IE2100 CNS Agents
4-5. When the
78-15870-01