Configuring Bgp Pe To Ce Routing Sessions - Cisco Catalyst 3750 Software Configuration Manual

Chapter 28 Configuring IP Unicast Routing
Command
Step 3 log-adjacency-changes
Step 4
redistribute bgp
autonomous-system-number subnets
Step 5
network network-number area area-id
Step 6
end
Step 7 show ip ospf process-id
Step 8
copy running-config startup-config
Use the no router ospf process-id vrf vrf-name global configuration command to disassociate the VPN
forwarding table from the OSPF routing process.

Configuring BGP PE to CE Routing Sessions

Beginning in privileged EXEC mode, follow these steps to configure a BGP PE to CE routing session:
Command
Step 1
configure terminal
Step 2
router bgp autonomous-system-number
Step 3
network network-number mask
network-mask
Step 4 redistribute ospf process-id match
internal
Step 5 network network-number area area-id
Step 6 address-family ipv4 vrf vrf-name
Step 7
neighbor address remote-as as-number
Step 8
neighbor address activate
Step 9
end
Step 10 show ip bgp [ipv4] [neighbors]
Step 11
copy running-config startup-config
Use the no router bgp autonomous-system-number global configuration command to delete the BGP
routing process. Use the command with keywords to delete routing characteristics.
78-15870-01
Purpose
(Optional) Log changes in the adjacency state. This is the
default state.
Set the switch to redistribute information from the BGP
network to the OSPF network.
Define a network address and mask on which OSPF runs
and the area ID for that network address.
Return to privileged EXEC mode.
Verify the configuration of the OSPF network.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Configure the BGP routing process with the AS number
passed to other BGP routers, and enter router
configuration mode.
Specify a network and mask to announce using BGP.
Set the switch to redistribute OSPF internal routes.
Define a network address and mask on which OSPF runs
and the area ID for that network address.
Define BGP parameters for PE to CE routing sessions, and
enter VRF address-family mode.
Define a BGP session between PE and CE routers.
Activate the advertisement of the IPv4 address family.
Return to privileged EXEC mode.
Verify BGP configuration.
(Optional) Save your entries in the configuration file.
Catalyst 3750 Metro Switch Software Configuration Guide
Configuring Multi-VRF CE
28-81