Panasonic KX-TVP200 Installation Manual page 86

INTEGRATING THE VPS WITH THE PANASONIC KX-TD DIGITAL PBX
From the SYS-PGM NO ? screen:
a)
Enter [116].
b)
Press the NEXT button (SP-PHONE).
c)
Enter the system number ([0] or [1], master/slave). The system displays the ROM
version and the date it was created.
This version must be P231U or higher for DPT Integration to be utilised (both systems
if system connection is used).
2.
Set the date and time using System Programme [000].
3.
Set PBX extension numbering using System Programme [003].
4.
Assign the Voice Mail Port. This programme tells the PBX which jack will be connected
to the VPS. This allows the PBX to send the proper DPT Integration information to those
ports.
Notes
• You can assign a maximum of 6 jacks (12 ports) with the KX-TD1232 or KX-
• If you are configuring a 2-cabinet system, all Voice Mail Ports should be assigned
From the SYS-PGM NO ? screen:
a)
Enter [117].
b)
Press the NEXT button (SP-PHONE).
Screen output: M: # # # #
c)
Enter the jack number (02-64) of the port you will use for the Voice Mail.
d)
Press STORE.
e)
Press END (HOLD) when finished.
Conditions:
5.
Skip this step unless setting flexible numbering.
System Programme [118] (Voice Mail Extension Number Assignment) is automatically
set. This programme allows you to assign an extension number to each Voice Mail port.
Since a jack connected to the VPS provides 2 extensions, this enables you to assign
extension numbers to each port. You can assign any extension number that is not already
assigned to another port. To reach the VPS, users dial these extension numbers. It is not
necessary to change the default programming for the extensions 165 and 166.
86
TD816.
to either the Master or Slave System.
Jack 01 cannot be used as a Voice Mail port. A jack
programmed as a Manager Extension (System
Programme [006]) cannot be used in this programme.
Installation Manual