Panasonic KX-TVP200 Installation Manual page 117

that COS. (This tells the VPS which paging group to dial). In the Intercom paging section,
assign the number "333" to the paging group assigned to the sales dept.
Fax Management (1-5-7-8)
Assigns up to 2 fax machines that can be extensions from the PBX. If the CNG tone is heard,
the VPS will automatically forward the call to the first fax machine. If the first fax machine is
busy or does not answer (is out of paper), the VPS forwards the call to the second fax machine.
This also allows to assign an extension as the fax manager to be notified on incoming faxes.
Disconnect Parameter (1-5-7-9)
Determines how many seconds of silence the VPS allows during a caller's message before
disconnecting the call.
RS-232C Settings (1-6-1)
Allows the System Administrator to change the baud rate, parity bit, etc.
Port Setting (1-6-2)
Only to be used when connecting the VPS to a PBX other than a KX-T series PBX. Use the
CPC control of the PBX for normal disconnect problems.
Dialing Parameters (1-6-3-1)
These parameters are set automatically when Quick Setup is conducted.
Most of the settings will be left unchanged. The only setting that will be changed quite often
is the Transfer Sequence for the operator or the extension. By default, it is set at FX on DPT
Integration and FTX for Inband Integration. In other words, the voice processor dials the flash,
waits for intercom tone and dials the extension number. By default, the VPS will stay on the
line to monitor the status of the call. If the extension user answers, the voice processor will
announce "you have a call" prior to releasing the call. This can be alleviated by adding the letter
"A" or "D" to the sequence. "A" stands for answer; the call will be transferred without the
announcement "you have a call". For a blind or unscreened transfer, add the letter "D" for
disconnect.
Installation Manual
CUSTOMISING THE SYSTEM
117