Panasonic KX-TVP200 Installation Manual page 189

FEATURE
Calling a Beeper
Installation Manual
DESCRIPTION
allows a subscriber to be notified by a beeper
when he has message(s). If the beeper has a
display, it is possible to send to it a callback
number. The callback number can be
recorded when a caller leaves a message. If
the caller does not leave a callback number,
the System Callback No., or the caller's
number if it is received through a telephone
company's Caller ID service, will be sent
instead.
To utilise this feature, follow the procedure
below.
1)
Go to the System Administration Top Menu,
and type 1-2 (Program-Class of Service) and
COS No.(1-63).
Select "Yes" in the Authorization for Message
Notification parameter. Make 1 selection
from the available options in the Beeper
Callback No. Entry Mode parameter.
2)
From the System Administration Top Menu,
type 1-1-1-Mailbox No.-Y-2-Device No.(1-3)
(Program-Mailbox Setting-Enter/Edit-
Mailbox No. Entry-Do you want to edit this
mailbox?-Notification Setting-Device No.
Entry).
For the Dial Number parameter: enter your
PBX's line access code before the beeper
number for dialing outward; enter an X after
the beeper number. (The X is for the caller to
enter his number as the callback number
which will later appear on your beeper.)
Finally, select "Beeper" in the Type of Device
parameter.
Table 32
• See "Dial Number" and "Type of
• See "Authorization for Message
• See "System Callback Number"
• See C3 SETTING COS
SYSTEM FEATURES
REFERENCES
Device" in Table 37 in
B2 SYSTEM
ADMINISTRATION—
MAILBOXES.
Notification" and "Beeper
Callback No. Entry Mode" in
Tables 39 and 40 in
B3 SYSTEM
ADMINISTRATION—
SETTING COS (CLASS OF
SERVICE) PARAMETERS.
in Table 62 in B6.7 Other
Parameters.
(CLASS OF SERVICE)
PARAMETERS.
189