Panasonic KX-TVP200 Installation Manual page 134

Voice processing system
Hide thumbs Also See for KX-TVP200:
Table of Contents

Advertisement

CUSTOMISING THE SYSTEM
Enter the data using the following table as a guide.
Parameter
Dial Number
Type of Device 1. Telephone
Use Mode
No. of Retries
Busy Delay
Time
No Answer
Delay Time
134
Value Range
(Default)
Up to 32 digits
Assigns a telephone or beeper number to Device 1, 2, or
consisting of 1-9,
3. The subscriber can also specify the dial number from
his telephone.
0, , #
P, T, M, X
P: Pause
(None)
T: Dial Tone Detection
M: Dial Mode Switching Code (Touchtone to Pulse, or
Pulse to Touchtone)
X: Callback Number Entry Code
1-9, 0, , #: Dial Codes
Note: The callback number entry code "X" must be
included in the number to be called if the Beeper
Callback No. Entry Mode is enabled through COS and
"Type of Device" is set to "Beeper". The proper number
of "Pauses" must be inserted before the callback entry
code.
Specifies the device to receive notification. This is
automatically set to "Beeper" when "X" is used in the
2. Beeper
Dial Number (above). The subscriber can also specify
(Telephone)
the type of device from his telephone.
1. Not Use
Specifies how Device 1, 2, or 3 is to be used. The
2. Continuously
subscriber can also specify the use mode from his
3. Scheduled
telephone.
(Continuously)
1. Not Use—Device 1, 2, or 3 is not used for a
2. Continuously—Device 1, 2, or 3 is called whenever
3. Scheduled—Device 1, 2, or 3 is called on a schedule
0-3 times
Specifies the number of times that a notification call to
(0)
Device 1, 2, or 3 should be attempted after a busy or no
answer condition is received.
0-120 min
Specifies the time (in minutes) the VPS must wait after
(3)
a busy condition is received before making another
notification call to Device 1, 2, or 3.
0-120 min
Specifies the time (in minutes) the VPS must wait after
(30)
a no-answer condition is received before making
another notification call to Device 1, 2, or 3.
Table 24
Description/Function
notification call.
a message is recorded in the mailbox.
basis when a message has been left in the mailbox.
Installation Manual

Advertisement

Table of Contents
loading

Table of Contents