Panasonic KX-TVP200 Installation Manual page 82

INTEGRATING THE VPS WITH THE PANASONIC KX-TD DIGITAL PBX
9.
Turn the power switch back on at the VPS and wait approximately 7-8 min while the
system initialises.
Before starting the VPS, make sure all installation and line connections have been
done as described in Section 2 INSTALLATION.
The calls to the VPS can be processed after the Power Indicator stops flashing.
After turning the power on, the system starts up in the following sequence:
• The Power Indicator light goes on.
• The Power Indicator light begins to flash.
• "CARD TEST" is displayed on the screen.
• "SYSTEM SETUP" is displayed.
Screen output:
CARD TEST...
SYSTEM SETUP...
1...
11... 12... 13... 14... 15... 16... 17...
• The VPS tests the CPU board, the hard disk drive, and
• Active ports are displayed on the screen.
Screen output:
Active COs: 1 2 3 4 5 6 7 8 9 10 11 12
DPT Interface Connection is Established
** ON LINE MODE **
The display will alert you if System Setup is not completed successfully.
Screen output:
Active COs: 1 2 3 4 5 6 7 8 9 10 11 12
DPT Interface Connection is not Established
** OFF LINE MODE **
This message will appear when the DPT connection between the VPS and telephone
system cannot be established.
82
2... 3... 4... 5...
the CO cards as "SYSTEM SETUP..." is displayed.
6... 7... 8... 9... 10...
Installation Manual