Panasonic KX-TVP200 Installation Manual page 83

Possible causes of the message: "DPT Interface Connection is not Established"
The PBX is not a KX-TD series system. Since
the VPS is configured to communicate with the
KX-TD1232, this message will always appear
when connecting to another type of PBX.
The cabling between the PBX extension ports
and the VPS is not 4-wire or is improperly
connected.
The PBX is a KX-TD series but does not have
the proper level of software required to support
DPT Integration.
The PBX is not programmed properly to support
DPT Integration.
10.
Start up completed.
a)
The Power Indicator light stops blinking when the start-up has been successful. (The
delay varies according to the system's condition.)
b)
"**ON LINE MODE**" is displayed.
c)
System prompt [>] is displayed on the screen. To enter system administration, Press
ENTER. All parameters can be set through the menu-driven programme.
Please Select Your Terminal Type.
1. ASCII TERMINAL
2. VT100
Please Enter the Number := ______
Installation Manual
INTEGRATING THE VPS WITH THE PANASONIC KX-TD DIGITAL PBX
Cause
When the System Administrator starts operation, the system asks for the terminal
type. By choosing VT100 [2], all parameters can be set through the menu-driven
programme.
Please Enter the Number:= [2]
Select [2] because Quick Setup is only available when using a personal computer that
can emulate a VT100 terminal.
Table 15
Connect a KX-TD series PBX
and set the PBX type by using
Quick Setup (see Section 5
CUSTOMISING THE
SYSTEM).
Confirm the cabling is
connected as described in
Section 2 INSTALLATION.
Consult your dealer
or use Inband Integration under
hardware settings.
Do required integration
programming as described in
this chapter.
Remedy
83