Table of Contents
Advertisement
SYSTEM MAINTENANCE AND TROUBLESHOOTING
7.1 INITIALISING THE SYSTEM
Initialising the system clears all voice data except user prompts and returns all system
parameters to their default settings. Throughout this section, menu selections are indicated as
"System Administration Top Menu-(Selection Number)". This means that the System
Administration Top Menu must first be accessed. On the first menu displayed, make the menu
selection corresponding to the first menu displayed. Repeat this process for each subsequent
menu when additional selection numbers are listed.
To initialise the system, follow the menu path as shown:
System Administration Top Menu-4
Note
In the following steps (steps 1 through 6), the output of the VT100 TERMINAL mode is
presented. The output of the ASCII TERMINAL mode is slightly different. For example, in
Step 1, "5: Quick Setup" does not appear when you are in the ASCII TERMINAL mode.
There are other differences, but the basic steps are the same.
1.
Go to the System Administration Top Menu
1 : Program
2 : System Reports
3 : Utility command
4 : System Reset/Clear
5 : Quick Setup
SELECT ITEM and PRESS Return-Key
2.
Type [4] for System Initialisation.
System Reset/Clear Menu
Mailbox No. Length :3
System Manager's Mailbox No. :999
Message Manager's Mailbox No. :998
Will you change the settings ? (Y/N): =
Note
Depending on the PBX extension numbering, the "Mailbox No. Length" might be 2
to 5.
148
Installation Manual
Advertisement
Table of Contents
Troubleshooting
