Sound Volume; Display Settings; User Parameters - Sirona SIROLaser Advance Operating Instructions Manual

Operation
Main home screen
48
Now the calibration check starts! Direct the correctly mounted handpiece
with correctly installed fiber to the head of your power meter.
WARNING
The calibration check takes place with laser power. Danger for skin and
eyes!
Do not direct the laser beam to flammable objects or use the laser with
flammable substances or gases around.
Do not direct the laser to reflective (metallic) surfaces. Danger for skin
and eyes!
The menu asks you to press the finger switch for 3 seconds.
1. Press the finger switch for at least 3 seconds, while directing the laser
Up to 7W
to the head of the power meter.
2. Readout the measured power from the display of your power meter.
3. Press 'OK'.Enter the measured power into the laser by using the
keyboard and press 'OK'.
4. Repeat the procedure for 3, 5 and 7 watt.
If the calibration check is passed successfully, the message "Calibration
Test passed" will appear.
➢ Acknowledge with 'OK'.
If the laser shows an error message, please contact your local service.
Calibration check with SIROLaser power meter
5.5.4.3.3
To be implemented in a later software version.

Sound volume

5.5.4.4
1. Select volume level of warning sound and press button sound by
using 'plus' or 'minus'.
 Level of warning and press button sound will immediately be
applied.
2. Save with 'OK'.

Display settings

5.5.4.5
1. Select level of display brightness by using 'plus' or 'minus'.
 Level of display brightness will immediately be applied.
2. Save with 'OK'.

User parameters

5.5.4.6
When entering the user parameters menu, the key user is already
configured, similar to a computer administrator. This administrator has
the possibility to enter five additional users (via new button).
Sirona Dental Systems GmbH
Operating Instructions SIROLaser Advance
63 74 198 D3545
D3545.201.06.03.02 05.2014