Information Messages; Switching Off The Laser Device - Sirona SIROLaser Advance Operating Instructions Manual

Sirona Dental Systems GmbH
Operating Instructions SIROLaser Advance
The calibration check was
successfully performed.
Confirmation via 'OK'.
For informations of the
calibration check, see
chapter "Calibration check"
[ ➙ 46].
empty
empty
63 74 198 D3545
D3545.201.06.03.02 05.2014

Information messages

5.5.5.3
The battery level is very low
(remaining power for 180
seconds) and needs to be
charged. Confirmation via
'OK'.
5.6

Switching off the laser device

Laser stop
In case of emergency press the laser stop button. Note, that the laser is
interrupted and deactivated, but not switched off. If you want to continue,
enter the pin code.
Main switch
During or after treatment the laser can be switched off by switching the
main switch at the rear of the unit. Here the laser diode is permanently
disconnected from power supply.
With rechargeable battery
NOTICE
The laser main switch does not disconnect the battery loading circuit,
i.e. the batteries are loaded even if the laser is switched off.
The laser has been
deactivated by pressing
"Laser Stop" button.
Confirmation via 'OK'.
Operation
Switching off the laser device
57