Switch On Power - Sirona SIROLaser Advance Operating Instructions Manual

Sirona Dental Systems GmbH
Operating Instructions SIROLaser Advance
63 74 198 D3545
D3545.201.06.03.02 05.2014
Up to 10 kHz
NOTICE
Alphabetic and numeric letters, limitation to data input:
• Numbers are displayed with English decimals '.' for all languages/
regions.
• The power is displayed with one decimal place. Unit is watt (W).
• The time can be set-up as continuous or 1 to 9999 seconds. If
continuous is selected it counts up to maximum 9999 seconds after
activating application. If time is fixed it counts down. Unit is seconds (s).
If 9999 is exceeded treatment will stop and display jumps back to
treatment screen.
• The duty cycle is displayed in 1% steps, from 1% to 100% without unit.
100% is displayed as CW.
• The frequency can be entered by typing in the numbers or by moving
higher or lower by using 'plus' or 'minus'. If using 'plus' or 'minus' the
frequency will be set from 1 Hz -10 Hz in increments of 1 Hz, from 10 Hz
-100 Hz in increments of 10 Hz, from 100 Hz -1 kHz in increments of
100 Hz and from 1 kHz -10 kHz in increments of 1 kHz. If 0 Hz is set,
CW is displayed. Unit is hertz (Hz).
• Between 1 kHz -10 kHz the duty cycle cannot be below 10% and
above 90% due to physical limits. So, at 1 kHz -10 kHz any input below
10% will automatically be displayed and used as 10% for the treatment
as well as any input above 90% will automatically turn into 90%.
• The energy will automatically be calculated and displayed with no
decimal place. Unit is joule (J). Before starting the application the to be
attained total energy will calculated and displayed if time is set. As soon
as application is started and time running the energy will be
accumulated as long as the laser is active.
• The average power wil automatically be calculated and displayed with
one decimal place. Unit is watt (W).
Clear screen before entering new parameters or data. Existing entries
will not be overwritten.
Newly generated applications or changed parameters of preset
applications will appear in red.
5.2

Switch on power

After starting the SIROLaser Advance by switching on the on/off button
on the backside of the control unit the yellow LEDs will blinking on.
While the SIROLaser Advance is booting information about the software
version and the set language as well as the advice to read the user
manual will be displayed.
When starting the SIROLaser Advance for the very first time you will
automatically be asked to set-up the unit. Please proceed as requested:
1. Country setting
Country setting, date & time, user parameters
For all users except US users: Change the pre-set country setting to
Non-US and confirm the selection.
Enter the pin code 3 3 3 4 and press 'OK '.
See also chapter "Country setting" [ ➙ 50].
 Now you will have access to the full range of pre-set indications.
Operation
Switch on power
35