Introduction; Embedded Diagnostic Control Mode; Entering Edc Mode; Edc Mode Tests - Xerox WorkCentre 3210 Service Manual

General Troubleshooting

Introduction

Embedded Diagnostic Control Mode

Entering EDC Mode

EDC Mode Tests

4-2
This chapter covers the diagnostic tools available in Embedded Diagnostic
Control (EDC) and Tech modes. Also covered are the Status LED and
troubleshooting procedures for problems not associated with a specific error
message.
For troubleshooting error messages, refer to Chapter 3, Error Messages and
Codes. Print-quality problems are covered in Chapter 5, Print-Quality
Troubleshooting.
Embedded Diagnostic Control (EDC) provides a suite of tests to check
operation of individual printer components. These tests are the best method
for determining the condition of the component being tested.
Enter EDC mode to run diagnostic tests on individual components. To enter
EDC mode, quickly press these buttons in sequence Menu > Stop > Left
Arrow > Back > OK > Right Arrow. COMPONENT TEST Press Menu Key
appears on the display when EDC mode is active. Press Stop to exit EDC
mode.
EDC Tests
Component Test
Cover Status Front Cover
Sensor Status Registration
Feed
Exit
Paper Empty
Motor Test Main Mtr Nor
Slow
Fan Test Fuser Fan
SMPS fan
LSU Fan
Clutch Test Pick Up Clutch
Regi Clutch
WorkCentre 3210/3220 Multifunction Printer Service Manual
Description
Test the interlock switch. Reports Open or Closed
Select which sensor to test. Actuator movement
toggles the display between With or Without
Paper. The Paper Empty test reports Present or
Empty.
Press the OK button after On appears on the
display. The Motor runs for 60 seconds the is
turned Off. Slow runs the motor for 60 seconds at
a slower speed.
Press OK after On appears on the display to run
the selected Fan for 10 seconds.
Press OK after On appears on the display to
activate the selected clutch for 3 seconds.