Power Save Mode; Reports; Configuration Report - Xerox WorkCentre 3210 Service Manual

General Information

Power Save Mode

Reports

Configuration Report

1-24
The Power Save mode is controlled by system firmware. In order to switch the
Ready state to the Power Save mode after a specified time, the main system
sends a sleep command to the engine. When the engine receives a sleep
command, it stops Fuser and Fan operation. The main system then sets the
engine to a sleep state.
The Power Save mode setting is accessed through the Control Panel. The
Power Save can be set from 1 to 120 minutes.
The following reports are available in the WorkCentre 3210/3220 printer. The
reports can be printed using the printer's Control Menu or CentreWare IS.
Report
Printer Configuration Page
Network Configuration Page
Supplies Information Report
Fax Phone Book
Email Address Book
Email Group Address Book
Fax Send Report
Fax Sent Report
Email Sent Report
Fax Receive Report
Schedule Jobs Report
Junk Fax Report
User Authentication Report
Print Cleaning Page
Two types of Configuration report are available: Printer Configuration report
and Network Configuration report.
WorkCentre 3210/3220 Multifunction Printer Service Manual
Print Method
Control Panel CentreWare IS (Network)
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
No
No
No
No
No
No
No
No
No
No
No