Close ( Terminates The I/O Processing Of A File ) - Mitsubishi QD51 Programming Manual

11 INSTRUCTIONS AND FUNCTIONS
CLOSE
Instruction
• Terminates the I/O processing of a file.
CLOSE
Syntax
file number
CLOSE
Examples
CLOSE #1
• The CLOSE instruction closes (terminates processing) a file that is completed for data I/O
Description
processing.
• Specify the file number opened by the OPEN instruction for <file number>.
• If <file number> is omitted, all files currently open are closed.
• Specify 1 through 8 for <file number>.
• All files are automatically closed if RUN, CLEAER, END, NEW, LOAD, CLOSE, or
SYSTEM instruction is executed, or if the program is edited.
Files are not closed, however, by the STOP instruction.
11 - 28
CLOSE
# <file number> [, # <file number> ... ]
• • • •
• • • •
• • • •
REMARK
See the OPEN, END, STOP, NEW, LOAD and CHAIN instructions, and Chapter 6.
Specify the file number that was opened by the
OPEN instruction.
Closes all files and terminates the I/O processing for
the file.
Closes the #1 file and terminates the I/O processing
for the file of file number 1.
MELSEC-Q
11 - 28