Mitsubishi QD51 Programming Manual page 429

11 INSTRUCTIONS AND FUNCTIONS
11 - 259
Format 2 control table
%(0) • • • • • • Format 2 control table
%(1) • • • • • • Specify the number of the network to be accessed.
See Section 4.2.2 for the allowable specification range.
%(2) • • • • • • Specify the station number of the PLC CPU to which data is
written.
See Section 4.2.2 for the allowable specification range.
%(3) • • • • • • Detailed error codes are stored here.
See Appendix 4.4.2 for the details about the error codes.
%(4) • • • • • • Processing code
%(5) • • • • • • Specify the device processing unit.
%(6) • • • • • • Specify the device using the defined code.
See Section 4.2.5 for the code numbers.
%(7) • • • • • • Specify the device number of the device specified in %(4).
See Section 4.2.5 for the allowable specification range.
Note, however, that values other than 0 or multiples of 16
cannot be specified for device numbers when writing to bit
devices in word units.
%(8) • • • • • • Specify the number of device points to be written, including
the device specified in %(6) and %(7).
The allowable specification range is as follows:
• When word units are specified
• Bit devices
• Word devices
• Specify 256.
• Specify 1.
• When reading in bit units • • • • • 1
• When reading in word units • • • 2
• When bit units are specified
• Bit devices
• When word units are specified
• Bit devices
• Word devices
MELSEC-Q
1 to 32 words
1 to 64 points
1 to 256 points
1 to 32 words
1 to 64 points
11 - 259