Mitsubishi QD51 Programming Manual page 361

11 INSTRUCTIONS AND FUNCTIONS
11 - 191
Format 2 control table
%(0) • • • • • • Format 2 control table
%(1) • • • • • • Specify the number of the network to be accessed.
See Section 4.2.2 for the allowable specification range.
%(2) • • • • • • Specify the station number of the PLC CPU from which
data is to be read.
See Section 4.2.2 for the allowable specification range.
%(3) • • • • • • Detailed error codes are stored here.
See Appendix 4.4.2 for the details about the error codes.
%(4) • • • • • • Processing code
%(5) • • • • • • Specify the program to be read.
Always specify 1 for PLC CPUs in which subprograms
cannot be used.
%(6) • • • • • • Specify the starting step count of the program to be read.
The maximum number of steps in the sequence program is
the capacity set by the parameter.
%(7) • • • • • • Specify the number of steps to be read.
The allowable specification range is from 1 to 64 steps.
• Specify 256.
• Specify 8.
• To read the main program
• To read subprogram (subprogram 1)
• To read subprogram 2
• To read subprogram 3
MELSEC-Q
• • • • • Specify 1.
• • • • • Specify 2.
• • • • • Specify 3.
• • • • • Specify 4.
11 - 191