Mitsubishi QD51 Programming Manual page 417

11 INSTRUCTIONS AND FUNCTIONS
11 - 247
Format 1 control table
%(0) • • • • • •
Specify the station number of the PLC CPU from which
data is to be read.
See Section 4.2.2 for the allowable specification range.
%(1) • • • • • •
Processing code
%(2) • • • • • • Specify the starting I/O number of the intelligent functional
module whose buffer memory data is to be read.
%(3) • • • • • • Specify the buffer memory address (lower digit) whose data
is to be read.
%(4) • • • • • •
Specify the buffer memory address (higher digit) whose
data is to be read.
%(5) • • • • • •
Specify the number of bytes of data to be read, including
the specified intelligent functional module/special function
module's buffer memory addresses.
The allowable specification range is as follows:
Format 2 control table
%(0) • • • • • •
Format 2 control table
%(1) • • • • • •
Specify the network number of the network to be accessed.
See Section 4.2.2 for the allowable specification range.
%(2) • • • • • •
Specify the station number of the PLC CPU from which
buffer memory is to be read.
See Section 4.2.2 for the allowable specification range.
%(3) • • • • • •
Detailed error codes are stored here.
See Appendix 4.4.2 for the details about the error codes.
%(4) • • • • • •
Processing code
%(5) • • • • • •
Specify the starting I/O number of the intelligent functional
module whose buffer memory data is to be read.
%(6) • • • • • •
Specify the buffer memory address (lower digit) whose data
is to be read.
%(7) • • • • • •
Specify the buffer memory address (higher digit) whose
data is to be read.
%(8) • • • • • •
Specify the number of bytes of data to be read, including
the specified intelligent functional module's buffer memory
addresses.
The allowable specification range is as follows:
• Specify 533 (&H215).
• Q series CPU
• QnA series CPU
• Specify 256 (&H100).
• Specify 533 (&H215).
• Q series CPU
• QnA series CPU
MELSEC-Q
1 to 1920 bytes
1 to 960 bytes
1 to 1920 bytes
1 to 960 bytes
11 - 247