Connecting To A Dc Power Supply - GRAPHTEC gl820 User Manual

Connecting to a DC Power Supply

Use the optional DC drive cable (B-514).
Use a power supply within the 8.5 to 26.4 VDC range.
(1) Configure the tip of the DC drive cable (B-514: 2m) to enable it to be connected to the DC power
supply.
(2) Connect the DC output side to the power supply connector on the GL820.
(3) Connect the DC input side to the DC power supply.
Be sure to check the polarity of the wire tips when performing wiring.
(4) Press the power switch on the GL820 to the ON side to turn on the power.
DC drive cable
(B-514: Option)
CHAPTER 2 Checks and Preparation
Shielded lead (- side)
White (+ side)
2−5