GRAPHTEC gl820 User Manual page 70

CHAPTER 3 Settings and Measurement
(4)-1 USER settings
User
Department name
Setting conditions
switch
(4)-2 About the Macro
Interface commands for GL820 can be described in a text file and read in. GL820 will operate asdescribed
in this file.
<Macro operation flow>
GL820 executes the commands
as described in the macro file.
Macro description example (file name: xxx.GMA)
3−34
Setting
Specify the user name. You cannot specify it as Guest.
Specify the department name. You cannot specify it as Guest.
Switches between Guest, User1 and User2.
Since setting conditions are stored for each user, they can be
called up easily by simply switching the user.
Create a macro file using a text editor on your PC
(save the file with extension "GMA").
Copy this file to a USB memory, and then connect
the USB memory to GL820.
Select the macro file and run the file.
▪ Macro file name:
▪ Execute Macro:
Refer to the "Interface Command Table" for details on commands supported by GL820 on a separatesheet.
The "Interface Command Table" is included in the CD. (Library folder : GL220_820_IF_Command.PDF)
Supported commands are limited to those relative to GL820 settings.
Read in commands cannot be used.
Description