Sirens & Sounders; Door Locks; Outputs; Chip Key - Abus Secvest User Manual

Hide thumbs Also See for Secvest:

Table of Contents

Important: ensure that you do not open the housing of a detector. Otherwise the system automatically

exits the walk test and triggers a tampering alarm. Detector housings are only opened by the specialist

installation contractor for maintenance purposes.

Under "Sub-areas" you can select whether only detectors from a certain sub-area are tested. Under "Zones"

you can select whether only certain detectors are tested. The procedure is then the same as for the walk test.

10.7.2 Sirens & sounders

Test the function of different sirens and sounders here. Click on "Change" to test the following:

• Internal sirens:

• External wireless sirens: If at least one wireless siren exists in the system, it can be tested here.

• Sounder Module

• Loudspeaker:

If a Secvest key and/or additional door lock is installed, it is a good idea to check its function occasionally.

Engage the lock while the alarm panel is disarmed – the message "Open" or "Closed" is displayed.

If a relay output is enabled this menu appears here. Click on "Select" and test the output using the "On/off"

function. If relay contacts (from the Secvest, universal module or wireless socket) have been enabled by the

specialist installation contractor, you can test these if necessary. The corresponding relay contact must be

enabled for you as the user in order to test it. There are relay contacts that only activate when an intruder

alarm is triggered and therefore cannot be accessed in this menu. Speak to your specialist installation

contractor if you wish to access a relay contact, for example to use a wireless socket for lighting control.

10.7.5 Proximity / chip key

If your system has a proximity chip key and you wish to test its function, take the key and swipe it over the

chip key reader area in the lower area of the alarm system (at the height of the ABUS logo). If the chip key is

read successfully, the display indicates which user the chip key is assigned to.

10. User menu

Test the installed sirens of the alarm panel and any indoor sirens here.

We recommend only briefly testing this function. Warn your neighbours

before testing if necessary.

If a universal module (UVM) is installed as a "siren module", you can test

its function here. Again: please warn your neighbours before testing.

Test the installed loudspeaker of the Secvest here. Select "Play/Stop"

to hear all existing messages in the system one after the other.

Table of Contents