Communication - Abus Secvest User Manual

Name/function
Version, language
Serial Number
Part No.:
Alarm panel time, date
Date & time
Zones
Wireless control panel
Wireless sirens
WAM
Door locks
Partitions
Outputs
Housing front tampering
Bell tampering
RF Jamming
Alarm panel A/C fault
External DC fault
Ext. DC voltage in
Battery status
Auxiliary

10.9.2 Communication

PSTN: Info => Communication => PSTN
GSM: Info => Communication => GSM
(This menu only appears when the GSM module is installed.) You can query information about the GSM (This menu only appears when the GSM module is installed.) You can query information about the GSM (This menu only appears when the GSM module is installed.) You can query information about the GSM (This menu only appears when the GSM module is installed.) You can query information about the GSM
Safety information 10. User menu
Explanation
Version number of the soft ware currently installed on the alarm system
Version number for the confi gured language
Serial number of the alarm system
Article number of the alarm system
Currently set time and date on the control panel
Synchronises date and time of the alarm panel with the date and time from
the PC via mouse click
Overview of available and confi gured zones
Number of components in use
Number of components in use
Number of components in use
Number of components in use
Number of sub-areas in use
Overview of available and confi gured outputs
Specifi es whether the tamper contact on the front of the housing has been
triggered
Specifi es whether the tamper contact on the wired, connected siren has been
triggered
Specifi es whether the alarm panel has detected RF jamming
Displays whether the alarm panel is connected to 230 V or if a fault is present
Displays whether the alarm panel is connected to 13.8 V external DC power
supply or if a fault is present.
Specifi es the voltage of the external DC power supply
Status of each battery (with voltage if required)
Output voltage to the power supply output terminal
PSTN link status query. The Secvest then checks the installed landline. If it is
not enabled or is disrupted, the error message "Error" appears. Otherwise the
message "Test successful" appears.
module here, such as IMEI, SIM card number (if supported by the provider) and
network operator. Select "Network", for example, and the network operator
and signal level are displayed.