Arming Sub-Areas - Abus Secvest User Manual

8.5 Arming sub-areas

In addition to the option of arming a sub-area via a user code, the system can also arm additional sub-areas.
The procedure for this is given here using the user code entry example. This function must be preconfi gured
by your specialist installation contractor.
Aft er entering the user code, you are asked to confi rm which sub-area(s) you wish to arm. Alternatively you
can also arm the complete system when, for example, you plan on leaving the premises.
8. Arming and disarming the system
1. In our example the alarm panel is divided into 4 sub-areas. These are
displayed as disarmed by the open padlock symbol. First enter your user code
as usual.
2. Once the user code has been entered, the menu changes as follows:
3. Select "Change" and the display changes as shown in the fi gure on the left .
Click "Done" to arm all sub-areas. The system is now completely armed.
4. If you only wish to arm certain sub-areas, click on "Change" and use the
key to navigate through the four sub-areas until the sub-area you wish to
arm is selected. Click on "Done" to arm the selected sub-area. Repeat the
same procedure to arm other sub-areas.