Operation Via Telephone - Abus Secvest User Manual

Disarm
To disarm the alarm panel unlock the additional door lock accordingly. Unlocking the lock automatically
disarms the alarm panel.

11.4 Operation via telephone

If the alarm panel is connected via the A/B interface, the wireless alarm panel can call you to
report an alarm. Once you have listened to the message, you can send commands to the system
by pressing the keys on your telephone keypad. The system sends information about the status
of your commands by playing back the voice messages (e.g. "Reset required"). You can also call
your wireless alarm panel if no alarm call has taken place, in order to check your alarm system:
1. Select the alarm system telephone number. You will then hear three beeps in succession.
2. Enter the access code via the telephone keypad. You will then hear two beeps in succession.
You can then use all of the following commands upon consultation with your specialist installation contractor.
The specialist installation contractor may still need to enable these commands before they can be used:
Role
Listen
Speak
Toggle between "Listen" and "Speak"
Playback messages
End call
End all calls
Disarm system
Arm system
Internally arm system
Stop sirens
Reset system
Query system
Switch output nnn to "On"
Switch output nnn to "Off"
Toggle output nnn
If you are called by the alarm panel in the event of an alarm, you do not need to enter the access code.
However, you can operate the system using key combinations 1, 2, 3, 5 and 9. Key combinations #0*0 etc.
must first be enabled by your specialist installation contractor before they can be used.
11. Advanced system operation
Key combination
1
2
*
3
5
9
#0*0
#0*1
#0*2
#1*0
#1*1
#3*
#9*nnn1
#9*nnn0
#9*nnn*
44 | 45