Remote Controls; Volume Settings; Web Access - Abus Secvest User Manual

Hide thumbs Also See for Secvest:

Table of Contents

10.5.4 Remote controls

Only visible to the administrator.

Assigned remote controls can be edited or removed here. The following options are available:

• Edit: press the * key of the remote control to reprogram it. The standard setting of the key is "Internal

arming". If you wish to switch a relay output with this key instead, however, this function can be

assigned to this key. A suitable relay output must fi rst exist in the system. Speak to your specialist

installation contractor if you require this function, such as to open the garage door via a relay output.

• Remove: remove a remote control that has been lost or is no longer needed. If you still have the

remote control, press any key. If you have lost the remote control, press "No remote control" to delete

it without having to press a key.

• Delete All you can delete all remote controls in the system at once here.

• Panic response: if the remote control has a panic alarm, this function can be disabled here. The "panic

alarm" on the remote control can be triggered by pressing both padlock keys at the same time.

Only visible to the administrator.

We recommend leaving alarm tones set to "9". If you set the volume of the alarm tones too low, you may

not hear an alarm in time or at all.

Only visible to the administrator.

Defi ne whether your system can be operated remotely (see "Web access") or not here:

• Disabled

web access disabled

• Enabled

web access enabled

10. User menu

Set the volume of diff erent tones here. The tones can be changed by directly

entering a number from 0–9, where 0 means muted and 9 represents

maximum volume.

Operation tones: refers to all tones that occur when the system is being operated

such as the feedback tones when operating the system via the keypad.

Info tones: refers to all info tones, such as feedback tones for error messages.

Alarm tones: The volume of the alarm tones (intrusion, fi re, etc.) can be changed

here. The volume of the messages can be changed by clicking "Select" and then

adjusting the volume using the +/- keys.

Table of Contents