Abus Secvest User Manual page 31

Hide thumbs Also See for Secvest:

Table of Contents

During an alarm

⋅

Voice dialler

⋅

Alarm panel

Example:

Alarms were triggered in the following zones in the following order:

Zone 226

Zone 225

Zone 203

The following can be heard over the system:

"The sub-area is deactivated! Attention! An alarm was triggered!

<Zone 225 voice message>, <Zone 226 voice message> Reset required"

Restart Panel

You can use this to restart the alarm panel manually.

This is helpful for some problems, to reset the alarm panel to a defined initial state. All the settings and

configurations are retained.

Note: This menu item is only visible to the administrator, i.e. the administrator must be logged into the

system.

A restart is only possible when

• all partitions are "disarmed" and

• the alarm panel has completed all important communications, transmissions and actions.

Select "Restart alarm panel" by pressing the "Change" menu key.

You are prompted for confirmation.

Press the "Yes" menu key.

At this point you can still cancel the restart.

Press "Back".

There are more details in Section 16.1, Manual restart (switching off and switching back on).

Keypad tones

When "On" is selected, a clicking sound via the loudspeaker is generated by pressing or touching each key.

10. User menu

Following an "individual message" and "Message x", the zone first triggered

will be announced in addition.

The zone first triggered will be announced with each sub-area. The sub-area

with the lowest number will be first.

Sub-area 3

Sub-area 1

Table of Contents