Arming Via Chip Key; Arming Via Delay Times - Abus Secvest User Manual

Hide thumbs Also See for Secvest:

Table of Contents

8.12 Arming via chip key

The chip key can be used to completely arm and disarm the wireless alarm panel (or

a sub-area, if there are any) without touching the panel itself. The chip in principle

eliminates the need to enter a code. If you as the user to whom the chip is assigned

are authorised to arm or disarm multiple sub-areas, you must then decide which area

to arm after you have swiped your chip key. The reader area for the chip key is located

at the height of the ABUS logo. You only have to swipe the chip in the proximity of the

reader area to arm the system – you do not have to touch the housing.

If you enter a code directly on the alarm panel (or via chip key or quick arm keys), the following "problem"

occurs: You must still be able to leave the premises through the doors. If the system were automatically

armed, you would not be able to leave the premises without triggering an alarm, if you have a magnetic

contact on the doors, for example. For this reason there is a "delay time". The delay times are preconfigured

by your specialist installation contractor.

There are generally two delay times:

• Exit delay

• Entry delay

The exit delay is set to 40 s as standard (the time can be adjusted by the specialist installation contractor

according to your needs, however). Following the start of the exit delay, the premises must be left within

this time.

Ensure that all windows and doors etc. are closed first before activation.

8. Arming and disarming the system

Table of Contents