Tcp/Ip Subnet Mask - QuickLabel Systems QLS-4100 Operation & Setup Manual

TCP/IP Subnet Mask

You will use the TCP/IP Subnet Mask option in the Communications menu
to set a subnet mask for the QLS-4100 Xe printer.
The default subnet mask is 255.255.255.1.
Note: For more detailed information on the topic of networking, refer to the
documentation applicable to your network environment and/or contact your
network administrator.
To set the TCP/IP subnet mask:
1 If the printer is in a Ready state, press the PRINT/PAUSE key to pause
the printer.
2 Press the NEXT or PREVIOUS key until the Communications menu is
displayed. Then press the SELECT key.
Pause: Communications
3 Press the NEXT or PREVIOUS key until the TCP/IP Subnet Mask menu
is displayed.
4 Press the + or – key to increase or decrease the first number in the
address, then press the SELECT key.
Press the + or – key to increase or decrease the second number in the
address, then press the SELECT key.
Press the + or – key to increase or decrease the third number in the
address, then press the SELECT key.
Press the + or – key to increase or decrease the fourth number in the
address, then press the SELECT key.
5 Press the SELECT key to confirm the TCP/IP subnet mask.
4-46
Press SELECT
TCP/IP Subnet Mask
255.255.255.1
Keypad controls and menus