Cutter - QuickLabel Systems QLS-4100 Operation & Setup Manual

Cutter

If using an optional cutter or cutter/stacker accessory, you can enable it using
the Cutter menu option.
To enable or disable the cutter:
1 If the printer is in a Ready state, press the PRINT/PAUSE key to pause
the printer.
2 Press the NEXT or PREVIOUS key until the Options menu is displayed.
Then press the SELECT key.
Pause: Options
3 Press the NEXT or PREVIOUS key until the Cutter menu is displayed.
4 Press the + or – key until the desired setting is displayed. Available
options are Enabled or Disabled.
5 Press the SELECT key to confirm your choice.
4-60
Press SELECT
Cutter
Enabled
Keypad controls and menus