Omron E5CN-HT Communications Manual page 61

Variable
Address Parameter name
type
C3 (83) 004C Communications Protocol Setting
(See note 1.)
C3 (83) 004D Send Data Wait Time (See note 1.)
C3 (83) 004E Control Output 1 Assignment
C3 (83) 004F Control Output 2 Assignment
Note 1: After communications parameters have been changed, perform a software reset or turn the power OFF and ON again, to
enable the changes.
Note 2: The output turns ON when the status of either the Control Output 1 ON/OFF Count Alarm or the Control Output 2 ON/OFF
Count Alarm turns ON.
3.1 Variable Area (Setting Range) List
Setting (monitor) value
H'00000000 (0): CompoWay/F
H'00000001 (1): Modbus
H'00000000 to H'00000063 (0 to 99)
When control output 1 is a linear output:
H'00000000 (0): Not assigned.
H'00000001 (1): Control output (heating)
H'00000002 (2): Control output (cooling)
When control output 1 is an ON/OFF output:
H'00000000 (0): Not assigned.
H'00000001 (1): Control output (heating)
H'00000002 (2): Control output (cooling)
H'00000003 (3): Alarm 1
H'00000004 (4): Alarm 2
H'00000005 (5): Alarm 3
H'00000006 (6): Program end output
H'00000007 (7): Control output ON/OFF count alarm (See note 2.)
H'00000008 (8): Stage output
H'00000009 (9): Run output
H'0000000A (10): Time signal 1 output
H'0000000B (11): Time signal 2 output
H'0000000C (12): Work bit 1
H'0000000D (13): Work bit 2
H'0000000E (14): Work bit 3
H'0000000F (15): Work bit 4
H'00000010 (16): Work bit 5
H'00000011 (17): Work bit 6
H'00000012 (18): Work bit 7
H'00000013 (19): Work bit 8
Same as for Control Output 1 Assignment.
Level
Communi-
cations set-
ting
Advanced
function
setting
3-11