Omron E5CN-HT Communications Manual page 48

SECTION 2 CompoWay/F Communications Procedures
2-24
Related
information
00 Default initialization values (See SECTION 3 Communica-
tions Data for CompoWay/F for details.)
(These settings are the same as the ones used when
"FACT" is selected for the setting data's set value initial-
ization.)
● Alarm Latch Cancel
The applicable alarm latch can be cleared with the related information
setting. The setting can be accepted in both setup area 0 and setup
area 1. An operation error will occur if communications writing is
disabled or if an non-volatile memory error occurs.
● SP Mode
Select program SP mode, remote SP mode, or fixed SP mode with the
related information setting. The setting can be accepted in both setup
area 0 and setup area 1. An operation error will occur in the following
situations.
• When AT is being executed.
• When the SP Mode parameter is disabled (not displayed at the
Controller).
● Invert Direct/Reverse Operation
Inverting or not inverting direct/reverse operation can be selected with
the related information setting. The setting can be accepted in both
setup area 0 and setup area 1. The related information specifications
are written to non-volatile memory according to the write mode settings.
An operation error will occur in the following situations:
• When AT is being executed.
• When inverting direct/reverse operation is set for an event input.
• When executed in manual mode.
● Infrared Communications Use
Select ON or OFF to enable or disable using infrared communications
with the related information setting. The setting can be accepted in both
setup area 0 and setup area 1.
● Hold
Turn the hold operation ON or OFF with the related information setting.
The setting can be made only in setup area 0. An operation error will
occur in the following situations.
• When AT is being executed
• During standby status
Explanation (initialization values)