Table of Contents
Advertisement
PTP 250 User Guide
Safety and regulatory information
This section describes important safety and regulatory guidelines that must be observed by
personnel installing or operating PTP 250 equipment.
Important safety information
To prevent loss of life or physical injury, observe the safety guidelines in this
section.
Power lines
Exercise extreme care when installing antennas near power lines.
Working at heights
Exercise extreme care when working at heights.
Grounding and protective earth
The Outdoor Unit (ODU) must be properly grounded to protect against lightning. It is the
user's responsibility to install the equipment in accordance with national regulations. In
the USA, follow Section 810 of the
In Canada, follow Section 54 of the
correct installation procedures for grounding the outdoor unit, mast, lead-in wire and
discharge unit, size of grounding conductors and connection requirements for grounding
electrodes. Other regulations may apply in different countries and therefore it is
recommended that installation of the outdoor unit be contracted to a professional installer.
Using the correct power supply
Always use the Motorola Power over Ethernet injector unit (PoE power supply) or Powered
Indoor Unit (PIDU Plus) to power the ODU. Failure to use the correct power supply could
result in equipment damage and will invalidate the safety certification and may cause a
safety hazard.
phn-2182_003v004 (Oct 2011)
National Electric Code, ANSI/NFPA No.70-1984
Canadian Electrical Code
UNDER DEVELOPMENT
. These codes describe
(USA).
I
Advertisement
Table of Contents
