Preparing for configuration and alignment
Preparing for configuration and alignment
This section describes the checks to be performed before proceeding with unit
configuration and antenna alignment.
Safety precautions during configuration and alignment
All national and local safety standards must be followed while configuring the units and
aligning the antennas.
Ensure that personnel are not exposed to unsafe levels of RF energy. The units
start to radiate as soon as they are powered up. Respect the safety standards
defined in
Compliance with safety standards
minimum separation distances.
Observe the following guidelines:
Never work in front of the antenna when the ODU is powered.
o
Always power down the PoE power supply (or PIDU) before connecting or
o
disconnecting the drop cable from either the power supply, ODU or LPU.
Regulatory compliance during configuration and alignment
All applicable radio regulations must be followed while configuring the units and aligning
the antennas. For more information, refer to
12.
Selecting configuration options
Use the installation report to determine which configuration options are required. Refer to
Chapter 2: Planning
6-2
considerations.
UNDER DEVELOPMENT
Chapter 6: Configuration and alignment
on page 4-8, in particular the
Compliance with radio regulations
phn-2182_003v004 (Oct 2011)
on page
4-