Using the installation wizard
Step 5: Confirm installation configuration
Step 5 of the Installation wizard is for reviewing and confirming the updated attributes
(Figure
6-18).
If any of the attributes are incorrect, select Back to return to previous steps and update
them.
If all attributes are correct, choose one of the following options:
•
If antenna alignment tones are not wanted, select Finish. This is the preferred option
before bench testing the units.
•
If antenna alignment tones are wanted, select Set Armed and Yes to confirm. This is
the preferred option before site installation and antenna alignment.
Figure 6-18 Step 5: Confirm Configuration page
If the IP Address, Subnet Mask or Gateway IP Address of the unit have been updated to
meet network requirements, then reconfigure the local management PC to use an IP
address that is valid for the network. Refer to
3.
6-22
UNDER DEVELOPMENT
Chapter 6: Configuration and alignment
Configuring the management PC
phn-2182_003v004 (Oct 2011)
on page
6-