Logging Into The Web Interface - Motorola PTP 250 User Manual

Connecting to the unit

Logging into the web interface

To log into the web interface as a system administrator, proceed as follows:
1
Start the web browser from the management PC.
2
Type the IP address of the unit (factory default is 169.254.1.1) into the address
bar. Press ENTER.
For user security, Motorola digitally signs its applications. On the first login, the
digital signature confirmation is displayed
content from this publisher' box and select Run.
The digitally signed Java app splash screen is displayed
the Login page.
3
When the Login page is displayed
Password (default 'motorola') and select Login.
4
On the first login to a new unit, or on the first login to a unit that has been reset
to full or partial default configuration, the Change Password page is displayed
(Figure
5
On the first login to a new unit, or on the first login to a unit that has been reset
to full default configuration, the Set Country Code page is displayed
Select the Country Code and select OK to confirm it is correct.
Ensure the correct Country Code is selected. An incorrect selection may result in
illegal radio operation. Once set, the Country Code can only be changed by using
the reset switch, as described in
reset)
6
The web interface menu and System Summary page are displayed
Continue with configuration.
6-6
6-7). Enter and confirm the new Password.
on page 7-26.
UNDER DEVELOPMENT
Chapter 6: Configuration and alignment
(Figure 6-4). Tick the 'Always trust
(Figure 6-6), enter the Username 'admin' and
Resetting to default configuration (with country
phn-2182_003v004 (Oct 2011)
(Figure 6-5), followed by
(Figure
(Figure 6-9).
6-8).