Motorola PTP 250 User Manual page 175

PTP 250 User Guide
To achieve best results, make small incremental changes to elevation and azimuth.
The action of tightening the mounting bolts can alter antenna alignment. This can be
helpful when fine-tuning alignment, but it can also lead to misalignment. To prevent
misalignment, continue to monitor receive signal level during final tightening of the bolts.
To align the antennas, proceed as follows:
1 At each end of the link, adjust the antenna to point at the other end of the link.
This should be done with the aid of a compass.
2
Without moving the master antenna, adjust the elevation and azimuth of the
slave antenna to achieve the highest receive signal level (using one of the
recommended methods in
3
Without moving the Slave antenna, adjust the elevation and azimuth of the
Master antenna to achieve the highest receive signal level (using one of the
recommended methods).
4 Repeat steps 2 and 3 as necessary to fine-tune the alignment to find the center of
the beam.
5
When the antennas have been aligned on the center of the beam, verify that the
receive level is within the predicted range (from the installation report). If this is
not the case, go back to step 2.
The current value of receive level can be verified by using
on page
Power attribute on the System Status page.
6 If after repeated attempts to align, the receive level still does not lie within the
predicted range, this may be because the data provided to the prediction tool
(such as PTP LINKPlanner) is inaccurate. For example estimates of path
obstructions, antenna heights or site locations may be inaccurate. Check this
data and update the prediction as necessary.
Once the antennas have been aligned correctly, tighten the integrated ODU (or
7
connectorized antenna) mountings. To ensure that the action of tightening does
not alter antenna alignment, continue to monitor received signal level.
phn-2182_003v004 (Oct 2011)
Monitoring received signal level
or by selecting menu option Status and monitoring the Receive
6-28
UNDER DEVELOPMENT
Aligning antennas
on page 6-26).
Graphical alignment
6-25