Nortel 1150E User Manual page 158

Regulatory and safety information
Table 9: EMC compliance
Jurisdiction Standard
European EN 55022
Community
EN 55024
EN 61000-3-2 Limits for harmonic current emissions
EN 61000-3-3 Limitation of voltage fluctuations and
Note: This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own
expense.
The user should not make changes or modifications not expressly
approved by Nortel Networks. Any such changes could void the
user's authority to operate the equipment.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
Note: The user should not make changes or modifications not
expressly approved by Nortel Networks. Any such changes could
void the user's authority to operate the equipment.
Description
Class A Emissions: Information
technology equipment - Radio
disturbance
Information technology equipment -
Immunity characteristics
Limits and methods of measurement
(equipment input current <= 16 A per
phase)
flicker in low-voltage supply systems for
equipment with rated current <= 16 A
158