Bypass; Changing/Deleting User Codes - Honeywell Apex Destiny 4100 User Manual

BYP ASS
N O TE:
12
BYP ASS
To enter BYPASS mode, your system must be disarmed. Make
sure the system is disarmed and follow the steps below:
Enter your code and immediately press the 9 key to
1.
gain entry into BYPASS mode. You will hear “BYPASSED
MODE, ENTER ZONE NUMBER.”
2. Enter the two digit number of the zone (use a leading zero if
necessary) you wish to bypass. You will hear “(description of
selected zone) BYPASSED (ON or OFF).” Only zones that
exist in the system can be bypassed. If an invalid zone
number is entered, refusal will be signaled by three beeps.
*
or A key. The yellow STATUS LED will light to
3. Press the
indicate that the zone is bypassed. A second push of the
A key within 10 seconds will remove the zone from bypass
and the yellow STATUS LED will clear.
Pressing 00 while in BYPASS mode will clear all bypassed
4.
zones.
Press the # or H key to exit BYPASS mode. You will hear
5.
“EXIT”.
NOTE: If ten seconds pass without pressing any keys, the system
will automatically exit BYPASS mode.
C H A N G IN G / DELETIN G USER C O DES
Assuming your primary code is 1,2,3,4:
Enter 1, 2, 3, 4, 7.
1.
2. The system will speak “ENTER USER NUMBER”.
3. Enter 2 digit user number, (01-08). The system will
speak "ENTER CODE X X" (X X = 01-08). You do
not need to clear a code to change a code.
Enter the new 4 digit code or hit the A key to delete
4.
the user code from step 3. If a new 4 digit code is
entered the system will speak “EXIT” after the 4th
digit. If a code is deleted the system will speak
“CODE OUT”.
*
or