Configuring A Dynamic Aggregation Group - H3C S3600V2 SERIES Layer 2-Lan Switching Configuration Manual

Step
4. Assign an Ethernet
interface to the
aggregation group.
5. Assign the port an
aggregation priority.
Configuring a Layer 3 static aggregation group
Step
Enter system view.
1.
2. Create a Layer 3
aggregate interface and
enter Layer 3 aggregate
interface view.
3. Exit to system view.
4. Assign an Ethernet
interface to the
aggregation group.
5. Assign the port an
aggregation priority.

Configuring a dynamic aggregation group

To guarantee a successful dynamic aggregation, be sure that the peer ports of the ports aggregated at
one end are also aggregated. The two ends can automatically negotiate the aggregation state of each
member port.
Command
a. Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
b. Assign the Ethernet interface
to the aggregation group:
port link-aggregation group
number
link-aggregation port-priority
port-priority
Command
system-view
interface route-aggregation
interface-number
quit
a. Enter Layer 3 Ethernet interface
view:
interface interface-type
interface-number
b. Assign the Ethernet interface to
the aggregation group:
port link-aggregation group
number
link-aggregation port-priority
port-priority
42
Remarks
Repeat these two sub-steps to assign
more Layer 2 Ethernet interfaces to
the aggregation group.
Optional.
By default, the aggregation priority
of a port is 32768.
Changing the aggregation priority of
a port might affect the aggregation
state of the ports in the static
aggregation group.
Remarks
N/A
When you create a Layer 3
aggregate interface, the system
automatically creates a Layer 3
static aggregation group numbered
the same.
N/A
Repeat these two sub-steps to
assign more Layer 3 Ethernet
interfaces to the aggregation
group.
Optional.
By default, the aggregation priority
of a port is 32768.
Changing the aggregation priority
of a port might affect the
aggregation state of the ports in the
static aggregation group.