Link Aggregation Configuration; Configuring A Manual Aggregation Group - H3C S3100-52P Operation Manual

Operation Manual – Link Aggregation
H3C S3100-52P Ethernet Switch

1.2 Link Aggregation Configuration

Caution:
The commands of link aggregation cannot be configured with the commands of port
loopback detection feature at the same time.
The ports where the mac-address max-mac-count command is configured cannot
be added to an aggregation group. Contrarily, the mac-address max-mac-count
command cannot be configured on a port that has already been added to an
aggregation group.
MAC-authentication-enabled ports and 802.1x-enabled ports cannot be added to an
aggregation group.
Mirroring destination ports and mirroring reflector ports cannot be added to an
aggregation group.
Ports configured with blackhole MAC addresses, static MAC addresses or the static
ARP protocol cannot be added to the aggregation group.
Ports where the IP-MAC address binding is configured cannot be added to an
aggregation group.
Port-security-enabled ports cannot be added to an aggregation group.

1.2.1 Configuring a Manual Aggregation Group

You can create a manual aggregation group, or remove an existing manual aggregation
group (after that, all the member ports in the group are removed from the ports).
For a manual aggregation group, a port can only be manually added/removed to/from
the manual aggregation group.
Table 1-1 Configure a manual aggregation group
Operation
Enter system view
Create
aggregation group
Configure a description
for the
group
Enter Ethernet port view
system-view
a manual link-aggregation
agg-id mode manual
link-aggregation
aggregation agg-id
agg-name
interface
interface-number
Chapter 1 Link Aggregation Configuration
Command
group
group
description
interface-type
1-8
Description
—
Required
Optional
By default, an aggregation
group has no description.
—