Configuring An Aggregate Interface; Configuring The Description Of An Aggregate Interface - H3C S3600V2 SERIES Layer 2-Lan Switching Configuration Manual

Step
2. Set the system LACP
priority.
3. Create a Layer 3
aggregate interface
and enter Layer 3
aggregate interface
view.
4. Configure the
aggregation group to
operate in dynamic
aggregation mode.
5. Exit to system view.
6. Assign an Ethernet
interface to the
aggregation group.
7. Assign the port an
aggregation priority.
8. Set the LACP timeout
interval on the port to
the short timeout
interval (1 second).

Configuring an aggregate interface

Most of the configurations that can be performed on Layer 2 or Layer 3 Ethernet interfaces can also be
performed on Layer 2 or Layer 3 aggregate interfaces.

Configuring the description of an aggregate interface

You can configure the description of an aggregate interface for administration purposes such as
describing the purpose of the interface.
To configure the description of an aggregate interface:
Command
lacp system-priority system-priority
interface route-aggregation
interface-number
link-aggregation mode dynamic
quit
Enter Layer 3 Ethernet
a.
interface view:
interface interface-type
interface-number
b. Assign the Ethernet interface
to the aggregation group:
port link-aggregation group
number
link-aggregation port-priority
port-priority
lacp period short
44
Remarks
Optional.
By default, the system LACP priority is
32768.
Changing the system LACP priority might
affect the aggregation state of the ports
in the dynamic aggregation group.
When you create a Layer 3 aggregate
interface, the system automatically
creates a Layer 3 static aggregation
group numbered the same.
By default, an aggregation group
operates in static aggregation mode.
N/A
Repeat these two sub-steps to assign
more Layer 3 Ethernet interfaces to the
aggregation group.
Optional.
By default, the aggregation priority of a
port is 32768.
Changing the aggregation priority of a
port might affect the aggregation state of
ports in the dynamic aggregation group.
Optional.
By default, the LACP timeout interval on a
port is the long timeout interval (30
seconds).