Ip Subnet-Based Vlan Configuration Example - H3C S3600V2 SERIES Layer 2-Lan Switching Configuration Manual

Step
5. Enter interface view or
port group view.
6. Configure port link
type as hybrid.
Configure the hybrid
7.
ports to permit the
specified IP
subnet-based VLANs
to pass through.
8. Associate the hybrid
ports with the specified
IP subnet-based VLAN.

IP subnet-based VLAN configuration example

Network requirements
As shown in
192.168.50.0/24.
Configure Device C to transmit packets over separate VLANs based on their source IP addresses.
Figure 46 Network diagram
Command
•
Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
•
Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
•
Enter port group view:
port-group manual
port-group-name
port link-type hybrid
port hybrid vlan vlan-list { tagged |
untagged }
port hybrid ip-subnet-vlan vlan
vlan-id
Figure 46, the hosts in the office belong to different IP subnets 192.168.5.0/24 and
Remarks
Use any command.
•
•
•
By default, all ports are access ports.
By default, a hybrid port allows only
packets from VLAN 1 to pass through
untagged.
Not configured by default.
140
The configuration made in Ethernet
interface view applies only to the port.
The configuration made in port group
view applies to all ports in the port
group.
The configuration made in Layer 2
aggregate interface view applies to
the aggregate interface and its
aggregation member ports. If the
system fails to apply the configuration
to the aggregate interface, it stops
applying the configuration to
aggregation member ports. If the
system fails to apply the configuration
to an aggregation member port, it
skips the port and moves to the next
member port.