Enabling Lldp Polling; Configuring The Advertisable Tlvs - H3C S3600V2 SERIES Layer 2-Lan Switching Configuration Manual

Enabling LLDP polling

With LLDP polling enabled, a device periodically searches for local configuration changes. On detecting
a configuration change, the device sends LLDPDUs to inform neighboring devices of the change.
To enable LLDP polling:
Step
1. Enter system view.
2. Enter Ethernet interface
view or port group view.
3. Enable LLDP polling and
set the polling interval.

Configuring the advertisable TLVs

To configure the advertisable LLDPDU TLVs on the specified port or ports:
Step
1. Enter system view.
2. Enter Ethernet interface
view or port group view.
3. Configure the
advertisable TLVs (Layer
2 Ethernet interface view
or port group view).
4. Configure the
advertisable TLVs (Layer
3 Ethernet interface
view).
Command
system-view
•
Enter Layer 2/Layer 3 Ethernet interface view:
interface interface-type interface-number
•
Enter port group view:
port-group manual port-group-name
lldp check-change-interval interval
Command
system-view
•
Enter Layer 2/Layer 3 Ethernet interface
view:
interface interface-type interface-number
•
Enter port group view:
port-group manual port-group-name
lldp tlv-enable { basic-tlv { all | port-description
| system-capability | system-description |
system-name } | dot1-tlv { all | port-vlan-id |
protocol-vlan-id [ vlan-id ] | vlan-name
[ vlan-id ] } | dot3-tlv { all | link-aggregation |
mac-physic | max-frame-size | power } |
med-tlv { all | capability | inventory |
location-id { civic-address device-type
country-code { ca-type ca-value }&<1–10> |
elin-address tel-number } | network-policy |
power-over-ethernet } }
lldp tlv-enable { basic-tlv { all | port-description
| system-capability | system-description |
system-name } | dot3-tlv { all |
link-aggregation | mac-physic |
max-frame-size | power } | med-tlv { all |
capability | inventory | location-id
{ civic-address device-type country-code
{ ca-type ca-value }&<1-10> | elin-address
tel-number } | power-over-ethernet } }
232
Remarks
N/A
Use either command.
Disabled by default.
Remarks
N/A
Use either command.
Optional.
By default, all types of LLDP
TLVs except location
identification TLVs are
advertisable on a Layer 2
Ethernet port.
Optional.
By default, all types of LLDP
TLVs, except IEEE 802.1
organizationally specific
TLVs, network policy TLVs,
and location identification
TLVs, are advertisable on a
Layer 3 Ethernet port.