Configuring One-To-One Vlan Mapping; Configuration Prerequisites; Configuring An Uplink Policy; Configuring A Downlink Policy - H3C S3600V2 SERIES Layer 2-Lan Switching Configuration Manual

Configuring one-to-one VLAN mapping

Perform one-to-one VLAN mapping on wiring-closet switches (see
and traffic type.
Perform these tasks to configure one-to-one VLAN mapping:
Task

Configuring an uplink policy

Configuring a downlink policy

Configuring the customer-side port
Configuring the network-side port

Configuration prerequisites

Create CVLANs and SVLANs, and plan CVLAN-SVLAN mappings.
Configuring an uplink policy
To configure an uplink policy to map each CVLAN to a unique SVLAN:
Step
1. Enter system view.
2. Create a class and enter class
view.
3. Specify a CVLAN as the
match criterion.
4. Return to system view.
5. Create a traffic behavior and
enter traffic behavior view.
6. Configure an SVLAN marking
action.
7. Return to system view.
8. Create a QoS policy and
enter QoS policy view.
9. Associate the class with the
behavior to map the CVLAN
to the SVLAN.
Configuring a downlink policy
To configure a downlink policy to map SVLANs back to CVLANs:
Description
Creates CVLAN-to-SVLAN mappings (required).
Creates SVLAN-to-CVLAN mappings (required).
Configures settings required for one-to-one VLAN mapping (required).
Configures VLAN settings required for normal communication
(required).
Command
system-view
traffic classifier tcl-name
[ operator { and | or } ]
if-match customer-vlan-id vlan-id
quit
traffic behavior behavior-name
remark service-vlan-id vlan-id
quit
qos policy policy-name
classifier tcl-name behavior
behavior-name
207
Figure 68) to isolate traffic by both user
Remarks
N/A
Repeat these steps to configure one
class for each CVLAN.
Repeat these steps to configure one
behavior for each SVLAN.
N/A
Repeat this step to create other
CVLAN-to-SVLAN mappings.